Evaluation of the polished surface characteristic of cobalt-chrome castings subsequent to various finishing and polishing techniques
Ponnanna, A.A.; Joshi, S.M.; Bhat, S.; Shetty, P.
Indian Journal of Dental Research Official Publication of Indian Society for Dental Research 12(4): 222-228
2001
ISSN/ISBN: 0970-9290 PMID: 11987661 Document Number: 6759
Finishing and Polishing constitutes an essential requisite after the fabrication of removable partial dentures. Improper finishing and polishing of cast framework will adversely affect the quality of functional units of partial dentures due to reduced dimensions. In this study the polished surface characteristic and loss of weight of the casting were evaluated and compared following different finishing and polishing techniques. A total number of thirty test specimens were cast and each surface finishing and polishing technique was carried out with a high speed polishing motor and an electropolishing unit under standardised conditions. Surface roughness was evaluated by means of a surface roughness analyzing instrument, Perthometer. The loss of weight due to the metal lost was observed on a sensitive electronic balance. The results of polishing technique employed with G3 group revealed better surface characteristic. It may be understood that sandblasting causes initial roughness and the sequence of coarse cylindrical abrasive, Black hard rubber polisher (coarse grit-Dentauram), Grey hard rubber polisher (Med-grit-Dentauram), Green hard rubber polisher (Fine-grit-Dentauram), Grey flexible rubber polisher (Fine grit-Renfert), felt buff with pumice slurry and felt buff with green polishing compound (Degussa) produced improved surface in this case. The loss of weight due to metal lost show concern with technique groups G4, G5, G6. It can be avoided by judicious sandblasting and application of proper grit of abrasive agents.
Document emailed within 1 workday
