An improved technique for dental alloy etching with a potentiostatic device
Hong, C.Y.
Proceedings of the National Science Council Republic of China. Part B Life Sciences 13(4): 319-326
1989
ISSN/ISBN: 0255-6596 PMID: 2700236 Document Number: 329845
Since a good retention of direct bonded retainers onto abutment teeth is the primary requirement for the fabrication of etched fixed partial dentures, successful formation of a micromechanical retentive architecture on the bonding surface is one of the most important procedures. For creating such a retentive dendritic pattern on nonprecious metal, a 2-electrode electrolytic method has been used. This equipment consists of a low-voltage DC power supply and two electrodes, namely, a working and a counter one. However, the current and voltage should be monitored during the entire processing time and the etching area must be pre-estimated. A potentiostat has been used to automatically stabilize the voltage across the working electrode and reference electrode by adjusting the current, as commonly employed in electro-chemical technology. A 3-electrode corrosion device originally developed for laboratory research was adapted for dental retainer etching in this study. The results revealed that the etching of dental nonprecious metal (Ni-Cr-Be alloy) could successfully be performed by using the system with a potentiostat. Moreover, the working potential was found to be approximately 1.3 volts by taking the midpoint between the breakdown and the critical potentials for passivation on the potentiostatic anode polarization curves. The optimal exposure time has been found to be in a range of 3 to 5 minutes and 4 minutes to be ideal as determined by SEM microphotographic observation which showed a uniform dendritic pattern with regular lattice form of alternating ridges and valleys.